Large grain size tungsten trioxide (wide spec tungsten trioxide) is a lower grade of tungsten trioxide powder that has the same density with tungsten trioxide, but at a much lower cost than pure WO3 powder. Tungsten trioxide with large grain size is specifically developed for various applications where the high density of tungsten is desired yet extreme purity is not required. Application of Large Grain Size Tungsten Trioxide To be applied for producing tungsten counterweight such as golf head counterweight,…
Tungsten Oxide
High density tungsten trioxide refers to the tungsten trioxide powder with higher density than common WO3 powder. It is applied for somewhere requires high density. Tungsten trioxide can be prepared from tungsten concentrate. The main methods to measure the content of tungsten trioxide in tungsten mine include gravimetric, volumetric, colorimetry, polarography, and atomic absorption spectrometry method, etc. In general, gravimetric and volumetric methods are suitable for the high levels of tungsten content. For the low level of tungsten content, colorimetry,…
High-purity ultrafine tungsten trioxide refers to the tungsten trioxide powder with purity of greater than or equal to 99.99%, apparent density of 0.28~0.3g/cm3. High-purity ultrafine WO3 has good catalytic performance for many reactions such as hydrodeoxygenation (HDO), oxidation, hydrocarbon isomerization and alkylation, etc. It is an important catalyst in petrochemical industry and has a very broad application prospect in the field of catalysis. WO3 also has good photochromic property and gas sensitivity. With the further development of material science, other…
Medium tungsten trioxide can be produced by ammonium paratungstate – sodium paratungstate complex salt method. The apparent density of the obtained tungsten trioxide is 0.8~1.0g/cm3. Producing Method Step one: Pour water into the complex salt to make into slurry and heat to boiling. Then, spray the slurry into 30%~31% concentrated hydrochloric acid solution which is simmering. The specific mass ratio: Complex salt: deionized water: hydrochloric acid = 1:0.36~0.38:1.06. It takes 0.5h or so in total reflux reaction under boiling. Step…
Coarse tungsten trioxide has an apparent density of 1.2~1.6g/cm3. Coarse WO3 has greater apparent density as its particle size is larger than fine tungsten trioxide of 0.5~0.7g/cm3. Producing Method The production of coarse WO3 is treating “ammonium paratungstate – sodium paratungstate complex salt” with saturated ammonium chloride solution, the specific steps are shown as follows: Add complex salt and saturated ammonium chloride solution with a solid-to-liquid ratio of 1: 5.5 in a reaction vessel equipped with a high speed stirrer.…
Fine tungsten trioxide can be prepared by double salt method with apparent density of 0.5~0.7g/cm3. Smaller the particle size, smaller the apparent density. Its specific production process is show as bellow: Mix double salt and water. And pour 30% to 31% concentration of cold hydrochloric acid slowly into the slurry. At the beginning, colloidal tungstic acid with white amorphous appearance is formed. The white tungstic acid turns into yellow tungstic acid precipitate with the continuous increase of the hydrochloric acid,…
Cobalt tungsten oxide, also called cobalt tungstate, is a kind of net gray powder with molecular formula of CoO4W. As a type of dingal material, it can be widely applied in catalyst, additive of pigment and microwave dielectric ceramic, etc. Preparation – Low Temperature Molten Salt Method The specific steps of low temperature molten salt method to produce nanometer cobalt tungstate is shown as bellow: 1. Mix LiNO3-Na2WO4 with molten salt, the mass ratio of 1.17: 1. 2. The mass…
Cadmium borotungstate is a kind of yellow triclinic crystal with toxicity, CAS No. of 1306-26-9, relative density of 3.28g/cm3, melting point of 75 °C, chemical formula of B2Cd5H36O98W24, molecular weight of 6600.06000, and the exact weight of 6610.14000. It is mainly used for the separation of ore. Characteristics 1. Its solution is yellow or light brown. 2. It is stable in the air. 3. It can be decomposed in sunlight. 4. It is easily soluble in water and more easily…
Strontium tungstate is a type of tungstate with tetragonal crystal system, CAS No. of 13451-05-3, relative density of 6.187g/mL (25/4°C), chemical formula of SrWO4, molecular weight of 335.45800 and exact weight of 335.83600. There are different purity including 99% (2N), 99.9% (3N), 99.99% (4N) and 99.999% (5N). SrWO4 is stable under room temperature and pressure. And it should avoid getting contact with oxidants and halogen. Solubility in water under 15°C is 0.14g/100mL H2O. It decomposes in acid. And it is…
Lead tungstate is a white to pale yellow powdery solid with the chemical formula of PbWO4, molecular weight of 455.03800 and CAS No. of 7759-01-5. It belongs monoclinic system. It is insoluble in water. And it is soluble in alkaline, sodium hydroxide solutions. It is available in 99.9% purity grade. Producing Methods 1. By heating tungsten powder and PbO2. 2. The reaction between tungsten powder and lead oxide (Ⅱ) under high temperature. 3. By mixing solutions of lead nitrate and…